Coal mine faces safety fines

Sep 28, 2012 The Associated Press

The mine's owners said they will challenge some of the findings.

Federal mining regulators hit a southwestern Wyoming coal mine with more than two dozen safety violations this week, ranging from the lack of an updated mine map to hydrants with low water pressure.

Owners of the Jim Bridger Coal Mine east of Rock Springs have vowed to fight at least one of the charges. The U.S. Department of Labor's Mine Safety and Health Administration said the mine has stopped production while safety changes are made.

The violations stem from an August inspection. Other safety allegations included an escape line dangling too high for all workers to reach and a segment of roof that wasn't properly supported.

The agency found that the company failed to properly examine and report a conveyor belt to which damage was "extensive and obvious and should have been noticed by any prudent examiner," according to the citation notice. The agency also issued what's known as an order regarding the conveyor, which means it found the company's actions were worse than ordinary neglect.

PacifiCorp, the mine's majority owner, said it will challenge the MSHA over some of its findings. Company spokesman Jeff Hymas did not elaborate on what exactly the company would challenge.

"The health and safety of our employees is of highest importance," the company statement said. "We are continually working to improve our programs and procedures in place to help ensure compliance with MSHA regulations and the well-being of our employees."

The mine operator chose to stop production while changes are made "to permit all conditions to be corrected" before restarting, said MSHA spokeswoman Amy Louviere.

The citations are part of a nationwide mine safety sweep.

The agency began monthly surprise inspections in April 2010 after an explosion at the Upper Big Branch Mine in West Virginia killed 29 miners.

Print Story
Read The Ranger...